Forum Replies Created

RE: Drive not responding

1. Check output current in each phase. 2. If output current is not equal in each then check IGBT & IGBT driving circuit. 3. Check output voltage at 50Hz without motor. 4. Check these thing then re...

In forum ABB ACS310 Drive

1 week ago
RE: Drive not responding

1. Remove fan & power-on drive then check. 2. After removing fan fault coming then check power card.

In forum ABB ACS310 Drive

4 weeks ago
RE: F0021 CURR MEAS Fault in ABB ACS550 Drive

Also check CT feedback voltage on 20 pins connector (9,10,11 upper layer from transformer side) you get 7V DC voltage which is CT feedback. - if you get different voltage then change CT. - After chang...

In forum ABB ACS550 Drive

4 weeks ago
RE: F0021 CURR MEAS Fault in ABB ACS550 Drive

Change CT, this problem comes when drive CT faulty.

In forum ABB ACS550 Drive

4 weeks ago
RE: 5696 PU state feedback Fault in ABB ACS880 Drive

yes

In forum ABB ACS880 Drive

2 months ago
RE: Drive output frequency not increasing if undervoltage control (Limit 30.31) in enabled

First thing what is input supply voltage mention on your drive name plate ? - if 380V - 480V mention then check your supply voltage - if your supply voltage is below above mention limit then undervo...

In forum ABB ACS580 Drive

2 months ago
RE: ABB ACS800 AP M TempFlt

Are you using any motor temp. sensor like PT100 or PTC ? What is parameter value 35.01 ? 1. Please check motor fan. 2. Check motor temp.

In forum ABB ACS800 Drive

2 months ago
RE: 5697 Charging feedback Fault in ABB ACS880 Drive

Please share drive complete part no.

In forum ABB ACS880 Drive

3 months ago
RE: 5697 Charging feedback Fault in ABB ACS880 Drive

Please describe condition of fault - comes after powerup or comes after giving run command. This fault also comes when you change control card or memory card. also check parameter group 95, please sha...

In forum ABB ACS880 Drive

3 months ago
RE: F001 fault in siemens master drive

Cause : Main contactor checkback - If a main contactor check back is configured, no check back occurs within the time set in P600 after the power-up command. In the case of externally excited synchron...

In forum SIMOVERT MASTERDRIVE

3 months ago
F001 fault in siemens master drive

How can resolve problem F001 fault in siemens master drive ?

In forum SIMOVERT MASTERDRIVE

3 months ago
RE: F01000 fault in siemens S120 Drive

Cause : Internal software error - An internal software error has occurred. Remedy: - evaluate fault buffer (r0945).- carry out a POWER ON (power off/on) for all components.- if required, check the da...

In forum SINAMICS S120/S150 Drive

3 months ago
F01000 fault in siemens S120 Drive

How can resolve problem F01000 fault in siemens S120 Drive ?

In forum SINAMICS S120/S150 Drive

3 months ago
RE: F1 fault in siemens V20 Drive

Cause : Overcurrent fault - • Motor power (P0307) does not correspond to the inverter power (r0206).• Motor lead short circuit• Earth faultsr0949 = 0: Hardware reportedr0949 = 1: Software reportedr094...

In forum SINAMICS V20

3 months ago
F1 fault in siemens V20 Drive

How can resolve problem F1 Overcurrent fault in siemens V20 Drive ?

In forum SINAMICS V20

3 months ago
Page 1 / 338