ABB ACS880 Drive 3-Wire Programming & Parameters – all parameter, control wiring, input & output power wiring and programming video.
Here is step by step programming of drive :
- Control wiring – for start/stop and speed reference.
- Power wiring – input and output wiring.
- Parameters – for start/stop, speed command and other parameters.
- Programming video – get all detail information process to enter parameter in drive.
Control Wiring
Power Wiring
Parameters
| ABB Standard | |||
| Factory Reset | 96.06 | 62 | Clear all |
| 96.04 | 1 | ABB Standard | |
| 20.01 | 4 | In1P Start; In2 Stop (3-wire) | |
| Motor Data | |||
| 99.06 | ……A | Motor Current | |
| 99.07 | ……V | Motor voltage | |
| 99.08 | ……Hz | Motor Freq | |
| 99.09 | ……rpm | Motor rpm | |
| 99.1 | ……KW | Motor Power | |
| Control Mode | 99.04 | 0 | DTC |
| 1 | Scaler | ||
| ID Run Request | 99.13 | 0 | No request |
| 1 | Normal | ||
| 2 | Reduced | ||
| 3 | Standstill | ||
| 4 | Autophasing | ||
| 5 | Current measurement calibration | ||
| 6 | Advance | ||
| Acceleration & Deceleration Time | For DTC Control | ||
| 23.12 | ….s | Acceleration Time 1 | |
| 23.13 | ….s | Deceleration time 1 | |
| 23.14 | ….s | Acceleration time 2 | |
| 23.15 | ….s | Deceleration time 2 | |
| Acceleration & Deceleration Time | For Scaler Control | ||
| 28.72 | ….s | Acceleration time 1 | |
| 28.73 | ….s | Deceleration time 1 | |
| 28.74 | ….s | Acceleration time 2 | |
| 28.75 | ….s | Deceleration time 2 | |
| Limit | |||
| Min speed | 30.11 | ….rpm | |
| Max speed | 30.12 | ….rpm | |
| Min Freq | 30.14 | ….Hz | |
| Max freq | 30.15 | ….Hz | |
| Max output current | 30.17 | ….A | |
| 30.19 | ….% | Min torque | |
| 30.2 | ….% | Max torque | |