Forum

Share:
Notifications
Clear all

CDS303 compressor drive and MCT10 software problem

6 Posts
2 Users
0 Reactions
520 Views
Posts: 3
Topic starter
(@roamer)
Active Member
Joined: 4 months ago

Hi all!!!

My first post here!

I have to connect to Danfoss CDS303 compressor drive with MCT10. Drive has no display or buttons, just 3 leds.

In all documentation it states that CDS is supported by MCT10, but I can not find it in the list of drives in the software itself.  When I try to connect to the drive either via USB or RS485, I get the message that unsuported drive is found on the network. I tried all versions available from danfoss.

Anybody has any idea why is this happening? Or is there maybe another software that covers CDS drives?

 

Thanks!!!

5 Replies
Posts: 18454
Admin
(@click2electro)
Member
Joined: 4 years ago

If possible arrange drive display then check.

Reply
Posts: 3
Topic starter
(@roamer)
Active Member
Joined: 4 months ago

Well I don't have one available. And I'm not sure if firmware revisions or something else would match if I get just some random display for danfoss drives.

I'd prefer to be able to connect with software.

Reply
3 Replies
Admin
(@click2electro)
Joined: 4 years ago

Member
Posts: 18454

@roamer If hardware issue in control card then PC communication not possible, so better option is connect display and check fault code.

Reply
(@roamer)
Joined: 4 months ago

Active Member
Posts: 3

@click2electro PC communication not possible because I can not find that model in the MCT10 program.

Reply
Admin
(@click2electro)
Joined: 4 years ago

Member
Posts: 18454

@roamer so without drive display not possible to identify fault.

Reply
Share: