Programming the Mitsubishi FR-E700 Variable Frequency Drive (VFD) involves setting up parameters to control motor speed, acceleration, deceleration, and other drive functions :

Step 1: Reset Default VFD

Press PU / EXT for the PU lamp to light up > Mode > Turn the crown > ALLC – Set “1”

Step 2: Set Parameter

• P77-Parameter write selection: “0”
• P160-User group read selection: “0”
• P1-Maximum frequency: “60Hz”
• P2-Minimum frequency: “0Hz”
• P3-Base frequency: “50Hz”
• P4-Multi speed setting (high speed): “60Hz”
• P5-Multi speed setting (middle speed): “3Hz”
• P6-Multi speed setting (low speed): “10Hz”
• P7-Acceleration time: “6s”
• P8-Deceleration time: “6s”
• P9-Electronic thermal O/L relay: Set follow Motor Current
• P82-Motor excitation current: Set follow 1/2 Motor Current
• P80-Motor capacity: Set folow Motor Power
• P83-Rated motor voltage: Set folow Motor Voltage
• P84-Rated motor frequency: Set folow Motor Frequency
• P79-Operation mode selection: “0”
• P71-Applied motor: “3”
• P72-Applied motor: “4”
• P150-Output current detection level: “115%”
• P22-Stall prevention operation level: “115%”
• P251-Stall prevention operation level: “1”