Mitsubishi Drives
1
Posts
1
Users
0
Reactions
330
Views
Aug 30, 2024 12:01 pm
Cause : PU stop comes when the motor is stopped using STOP/RESET button under the mode other than the PU operation mode.
"P5" fault in mitsubishi drive indicate "PU stop" condition. This means the running motor is stoped by pressing keypad "STOP" button.
- Check for a stop made by pressing STOP/RESET button of the operation panel.
- Power off drive and wait 5 min then restart drive.
- To enable STOP/RESET button under the mode other than the PU operation mode, set Pr.75 Reset selection/disconnected PU detection/PU stop selection.
