Nidec & Control Techniques Commander C200, C300, NE200 & NE300 Drive
1
Posts
1
Users
0
Reactions
143
Views
Apr 08, 2024 5:35 am
Cause : Autotune test stopped before completion comes when the drive was prevented from completing an autotune test, because either the drive enable or the drive run were removed.
- Check the drive enable signal (Terminal 31 & 34 on size 1 to 4 or terminals 31 & 35 on size 5 to 9) were active during the autotune.
- Check the run command was active in digital input 3 or 4 state (Pr 08.003 or Pr 08.004) during the autotune.
