click2electro

Cause: Analog input wire breakage comes when the wire-break monitoring for an analog input has responded. The input current of the analog input has undershot the threshold value. f3505 siemens indica...

Cause: Internal fault comes when there is an hardware issue in drive power card or control card. This means there is a communication error between the control card and the power card. danfoss a38 faul...

Cause: Short-circuit/ground fault detected comes when a connection between one or more of the motor phases and the ground (earth) connection. This can also occur in the motor, cable, or drive. siemens...

Cause : Overtemperature heat sink AC inverter comes when the temperature of the power unit heat sink has exceeded the permissible limit value due to insufficient cooling, fan failure, overload, ambien...

Cause: Motor blocked comes when the motor is unable to rotate freely, preventing the drive from achieving the desired speed. The motor is drawing more current than its rated value for an extended peri...

Cause: Motor phase U missing comes when the drive has detected an interruption or absence of voltage on the U-phase connection between the frequency converter and the motor. danfoss vfd alarm 30 indic...

Cause: External Interlock comes when a safety feature that requires an external switch or safety circuit to be closed before the drive can start the motor. If this circuit is open, the drive will disp...

Cause : Motor overspeed comes when the maximum permissible speed was either positively or negatively exceeded or the maximum permissible positive speed. f7901 fault in siemens drive indicates motor ov...

Cause: Motor blocked comes when the motor is unable to rotate freely or is mechanically obstructed. The motor is facing excessive resistance and cannot rotate freely. siemens f07900 indicates motor bl...

Cause: Fan has reached the maximum operating hours comes when the maximum operating time of at least one fan will soon be reached, or has already been exceeded. a30042 siemens alarm indicates fan has ...

Cause: Initialization Required comes when the drive, control board, or terminal board has been replaced and the parameter settings between the control board and the terminal board no longer match. ope...

Cause: Fan has reached the maximum operating hours comes when the maximum operating time of at least one fan will soon be reached, or has already been exceeded. a30042 sinamics indicates fan has reach...

Cause: Position Error out of range comes when the actual motor position differs too much from the commanded position beyond a preset allowable limit. delta al009 indicates a position Error out of rang...

Cause: Safety hardware fault comes when the drive detected an issue with the safety input circuit that prevents unintended motor starts and protects personnel from operational hazards. powerflex f111 ...

Cause: Defect in a monitoring channel comes when the drive-integrated "Safety Integrated" function on processor 1 has detected a fault in the crosswise data comparison between the two monitoring chann...