click2electro

Cause: Current limit comes when the motor's rated power might be too high for the selected inverter. This is a warning, not a fault that trips the drive, but it signifies that the inverter is operatin...

Cause: Overcurrent condition during acceleration comes when drive detected a large output current exceeding protection limits, and it tripped instantly to protect itself. e0c1 mitsubishi indicates an ...

Cause: Overcurrent comes when the motor is trying to drive a load that is too heavy, causing it to draw more current. This could be due to a mechanical jam, binding, or the load being significantly la...

Cause: Drive Overload comes when the drive itself is experiencing an overload condition. This fault comes due to various reasons, including excessive load demands, electrical issues, or internal compo...

Cause : External fault 1 comes when an external input wired into the drive has triggered a fault. The drive is configured to monitor a digital input, and that input is signaling FAULT. f07860 fault in...

Cause: Control Circuit Error comes when there is a self-diagnostic error in the control circuit or connector on the operator is damaged. This fault also comes when there is hardware issue in drive. cp...

Cause: Internal fault comes when there is an hardware issue in drive power card or control card. This means there is a communication error between the control card and the power card. danfoss a38 alar...

Cause: Button disabled comes when the buttons on the LCP might be intentionally disabled through the parameter settings. If the drive is configured for remote control via fieldbus (e.g., Profibus, Eth...

Cause : Over current comes when the current of the main circuit is more than the instantaneous current of the servo drive. This is a serious alarm that signifies the drive has detected an excessive am...

Cause : Supply voltage incorrectly parameterized comes when the measured DC voltage lies outside the tolerance range after pre-charging has been completed. f6310 siemens indicates supply voltage incor...

Cause: Short circuit comes when there is short circuit between motor or motor cable. This fault also comes when there ia an hardware issue in drive. alarm 16 danfoss indicates short circuit. This mean...

Cause: Hardware monitoring active comes when there is hardware issue in drive power card or control card. This fault signifies that the drive detected an issue during its internal hardware checks. mi...

Cause : Incorrect motor data identification comes when an attempt to perform motor data identification (also known as motor parameter identification or commissioning) but there is an issue with motor ...

Cause : HW OverCurrent comes when the drive output current has exceeded the hardware current limit. The drive detected an extremely high current spike that bypassed software control, the hardware prot...

Cause : Motor stalled comes when the drive detects that the motor is not rotating as expected based on the commanded speed and the motor model within the drive. The drive has detected that the motor i...