click2electro

Cause : Excessive Deviation of Position Command comes when the actual position of the motor shaft deviates too much from the commanded position. al009 delta indicates a "Position Error out of range" i...

Cause: Safe Stop Activated comes when safe Torque Off (STO) has been activated. The drive's Safe Stop function typically requires a 24V DC signal at a designated digital input terminal (often terminal...

Cause: Motor blocked comes when the motor is unable to rotate freely or is mechanically obstructed. The motor is facing excessive resistance and cannot rotate freely. f7900 fault indicates motor block...

Cause: Parameter Range Setting Error comes when one or more parameters in the drive have been programmed with a value that exceeds the permissible upper or lower limit for that specific parameter. ope...

Cause: Current limit comes when the drive is limiting output current to protect itself or the motor, but it hasn’t tripped yet. This is a warning, not a fault, but it's a sign that something's pushing...

Cause: Precharging DC link time monitoring comes when the power unit DC link was not able to be pre-charged within the expected time. This means the precharging of the DC link capacitors took too long...

Cause: DC link voltage undervoltage comes when the voltage in the DC link of the drive has fallen below a permissible threshold. The incoming AC mains voltage might be too low or experiencing signific...

Cause: Motor overtemperature comes when the drive has detected that the motor temperature has exceeded a permissible limit. The motor is drawing more current than its rated capacity for an extended pe...

Cause: Overcurrent when constant speed running comes when the acceleration ramp-up time is set too short, the motor will draw excessive current to reach the target speed quickly. oc3 fault invt indica...

Cause: Overload I2t comes when the power unit has experienced an overload condition based on the current and the duration of the overload. f30005 fault in siemens drive indicates a motor overload bas...

Cause: DC link voltage overvoltage comes when the DC bus voltage inside the drive has exceeded its safe operating limit. This fault usually caused by regeneration (braking energy returning to the DC l...

Cause: Sign-of-life failure for master control comes when the active PC master control, no sign-of-life was received within the monitoring time. The master control was returned to the active BICO inte...

Cause: Motor data identification activated comes when that motor data identification is currently running or has been started. a7991 fault in siemens drive indicates Motor data identification activate...

Cause: Motor data identification activated comes when the motor data identification function has been activated. This function is crucial for the drive to accurately control the connected motor by lea...

Cause: Motor overtemperature comes when the motor temperature has exceeded the limit defined in the drive settings. If the motor has a built-in temperature sensor (e.g., PTC, KTY, thermistor) and this...