Cause : Motor auto-tuning fault comes when the drive encounters problems while trying to automatically tune the motor parameters for optimal performance. Auto-tuning is crucial for adjusting the drive to match the specific characteristics of the motor, such as its inductance, resistance, and speed. If auto-tuning fails, it can affect the drive’s performance and the motor’s operation.

"E19.15" fault in inovance MD800 drive indicate Motor auto-tuning error. This means a problem in motor auto-tune process, preventing the drive from accurately controlling the motor.

Possible Causes:

1. Motor Configuration Issues: Incorrect motor parameters or mismatches between the motor and drive settings can prevent successful auto-tuning.
2. Mechanical Problems: Mechanical issues such as binding, excessive friction, or misalignment in the motor or driven load can interfere with the auto-tuning process.
3. Electrical Issues: Problems with the motor’s electrical connections, such as faulty wiring or poor insulation, can affect the tuning process.
4. Insufficient Power Supply: Fluctuations or instability in the power supply can impact the auto-tuning process.
5. Drive Settings: Incorrect drive settings or parameters related to auto-tuning can cause the process to fail.
6. Faulty Motor or Drive: Issues with the motor or the drive itself, such as damaged components or firmware problems, can lead to auto-tuning faults.

Troubleshooting Steps:

1. Verify Motor Configuration:

   • Check Motor Parameters: Ensure that the motor parameters, such as voltage, current, and rated speed, are correctly entered into the drive. Verify that these settings match the motor’s specifications.
   • Review Drive Settings: Confirm that the drive’s auto-tuning settings are configured correctly. Refer to the drive’s manual for the proper setup.

2. Inspect Mechanical System:

   • Check for Binding or Friction: Ensure that the motor and driven load are free from mechanical issues such as binding, jamming, or excessive friction. Correct any mechanical problems before attempting auto-tuning again.
   • Verify Alignment: Ensure that the motor is properly aligned with the driven equipment and that there are no misalignments.

3. Examine Electrical Connections:

   • Inspect Wiring: Check all electrical connections between the drive and the motor for signs of damage, loose connections, or improper installation. Repair or replace any faulty wiring.
   • Test Insulation: Verify the motor’s insulation resistance to ensure that it is within the acceptable range.

4. Check Power Supply Stability:

   • Monitor Power Quality: Measure the power supply voltage and ensure it is stable and within the specified range for the drive and motor.
   • Address Fluctuations: If there are power supply issues, address them to provide a stable power source for the drive.

5. Review and Adjust Drive Settings:

   • Check Auto-Tuning Parameters: Verify that the parameters related to auto-tuning are correctly configured. Make adjustments if necessary based on the drive’s manual.
   • Reset Settings: If needed, reset the auto-tuning settings to default and reconfigure them.

6. Test Motor and Drive Functionality:

   • Perform Motor Tests: Use diagnostic tools to check the motor’s performance and verify that it is functioning correctly.
   • Update Firmware: Ensure that both the motor and drive firmware are up-to-date and compatible.