click2electro

E67.00 fault in inovance IS580 drive indicates Parameter initialization fault. This means the drive encountered a problem reading or loading its internal parameters during startup or initialization. ...

E66.02 fault in inovance IS580 drive indicates "Braking resistor resistance smaller than minimum". This means the drive has detected that the resistance of the connected braking resistor is too low, p...

E66.01 fault in inovance IS580 drive indicates Braking resistor disconnected. This means the drive has detected the braking resistor is either not connected or there is an open circuit in the braking ...

E63.00 fault in inovance IS580 drive indicates Reverse running time reaches A4-09. This means the drive has detected the motor running in reverse direction longer than a configured time limit. Increa...

E62.02 fault in inovance IS580 drive indicates Braking IGBT gets overloaded. This means the braking IGBT is experiencing an overcurrent or thermal overload condition during braking. Check if braking ...

E62.00 fault in inovance IS580 drive indicates Braking IGBT short-circuit. This means the braking IGBT has detected a short-circuit condition. Essentially, the braking transistor (IGBT) inside the dri...

E61.00 fault in inovance IS580 drive indicates Braking IGBT works overtime. This means the braking transistor is being activated more often or for longer durations than it should be, which can lead to...

E59.00 fault in inovance IS580 drive indicates Back EMF fault during auto tuning. This means the back EMF signal is abnormal, outside expected limits, or missing. It can be caused by wiring issues, in...

E58.00 fault in inovance IS580 drive indicates Restore without saving user parameters. This means the drive undergoes a parameter restore/reset operation (e.g., factory reset or restore defaults), but...

E52.00 fault in inovance IS580 drive indicates Multi masters fault. This means more than one master device is detected on a single communication bus (e.g., CANopen, CANlink, Modbus RTU). The network p...

E49.02 fault in inovance IS580 drive indicates Speed sensor interfered. This means the drive is detecting abnormal or unstable signals from the speed sensor — likely due to electrical interference, si...

E49.01 fault in inovance IS580 drive indicates Speed sensor disconnected. This means the drive cannot detect a signal from the speed sensor (encoder, resolver, or pulse generator) connected to the mot...

E48.00 fault in inovance IS580 drive indicates Communication address conflict. This means the drive has detected that two or more devices on the same communication network (e.g., CANopen, Modbus, CANl...

E47.00 fault in inovance IS580 drive indicates Slave fault. This fault typically occurs in multi-axis systems or networked systems where the IS580 drive acts as a master communicating with one or more...

E46.03 fault in inovance IS580 drive indicates that the "pressure sensor output is beyond setting range". This means the analog signal from the connected pressure sensor is outside the acceptable rang...