click2electro

E46.02 fault in inovance IS580 drive indicates pressure sensor calibration fault. This means the drive has detected a problem during the pressure sensor calibration process, indicating the sensor read...

E46.01 fault in inovance IS580 drive indicates "Motor rotor gets locked or pump gets stuck". This means the drive detects that the motor rotor is not turning despite power being applied, or that the p...

E46.00 fault in inovance IS580 drive indicates "Pressure sensor is faulty". This means the drive has detected a problem with the pressure sensor input signal. Check cables, connectors, and terminals ...

E45.03 fault in inovance IS580 drive indicates Motor KTY overheat. This means the drive has detected that the KTY sensor resistance indicates the motor is overheating. The drive monitors the resistan...

E45.02 fault in inovance IS580 drive indicates PG card flat cable fault. This means drive is detecting an issue with the communication ribbon cable (flat cable) between the PG card (encoder interface ...

E45.01 fault in inovance IS580 drive indicates "Temperature sensor disconnected". This means the drive is configured to monitor a motor temperature sensor (typically a PTC, NTC, or RTD like PT100), bu...

E45.00 fault in inovance IS580 drive indicates Motor PTC overheat. This means the resistance of the PTC exceeds a set threshold. Power off and allow the motor to cool for 15–30 minutes. Make sure PTC...

E44.03 fault in inovance IS580 drive indicates "Drive parameter setting fault and speed sensor fault". This means the drive parameters are incorrectly configured and there is also a problem with the s...

E44.02 fault in inovance IS580 drive indicates Speed sensor fault. This means the drive is not receiving valid or reliable feedback from the connected speed sensor — such as an incremental encoder or ...

E44.01 fault in inovance IS580 drive indicates "Drive parameter setting fault". This means one or more critical parameters in the drive are set incorrectly, inconsistently, or outside acceptable range...

E44.00 fault in inovance IS580 drive indicates "Speed error exceeds limit". This means the speed error has exceeded its allowable limit — meaning the actual motor speed deviates too much from the targ...

E43.00 fault in inovance IS580 drive indicates "Speed sensor fault during motor auto tuning". This means the motor auto-tuning process fails due to incorrect or missing feedback from the speed sensor ...

E42.07 fault in inovance IS580 drive indicates Canopen fault. This means the drive has detected an issue while trying to communicate over the CANopen protocol — a standard for CAN-based communication ...

E42.06 fault in inovance IS580 drive indicates Canlink address setting fault. This means that the CAN node address configured on the drive is invalid, missing, or outside the acceptable range, which p...

E42.05 fault in inovance IS580 drive indicates Canlink address conflicts. This means there is a CANlink address conflict detected on the CAN bus network. This happens when two or more devices on the C...